PROAIR MULTI-ZONE CONTROL SYSTEM
PROAIR MULTI-ZONE motorised circular damper / motorised circular by-pass for system
The motorised circular dampers for the "Proair Multi-zone" system integrate perfectly into new and existing ducted systems, communicating directly with the system control unit.
The dampers connect to each other by means of the cascading system.
The connection cable used is of the 8-wire telephone type with RJ45 plug connection, present in this catalogue in different sizes already with wired connector.
Appropriately configured using the "Polaris” control unit, the damper can take on the function of a motorised circular bypass.
The automatic or manual management of the damper allows the butterfly to move to one of the 4 positions pre-set by the system: 0%, 33%, 66% and 100%.
Attention! Use only Tecnosystemi cables - do not use cables other than those indicated in order not to compromise the correct functioning of the system.
There must always be an inspection hatch to access the control unit and the dampers.
Always install the dampers with the motor facing downwards.
- Removable motor that can be positioned at: 0° - 90° - 180° 270° - 360°
- Made of anti-condensation plastic
- Ensures thermal insulation between the inner and outer surfaces
- Ø COUPLER [mm] 150
- H [mm] 230
- L [mm] 230
- MAX. AIR FLOW RATE [m³/h] 388
- Ø COUPLER [mm] 200
- H [mm] 280
- L [mm] 250
- MAX. AIR FLOW RATE [m³/h] 678
- Ø COUPLER [mm] 250
- H [mm] 330
- L [mm] 280
- MAX. AIR FLOW RATE [m³/h] 1060
- Ø COUPLER [mm] 300
- H [mm] 380
- L [mm] 350
- MAX. AIR FLOW RATE [m³/h] 1526
